3-79
Note 2. Use setting 2 or 4 when displaying speeds of 1,000 r/min or greater.
Setting Display data Cams used for 3FF88L-160 Cams used for 3FF88L-162
1 4-digit present angle
output (no units)
CAM 13 to 16: Display data
CAM 12: 1st digit LE signal
CAM11: 2nd digit LE signal
CAM10: 3rd digit LE signal
CAM 9: 4th digit LE signal
CAM 29 to 32: Display data
CAM 28: 1st digit LE signal
CAM 27: 2nd digit LE signal
CAM 26: 3rd digit LE signal
CAM 25: 4th digit LE signal
2 4-digit speed output
(no units)
CAM 13 to 16: Display data
CAM 12: 1st digit LE signal
CAM11: 2nd digit LE signal
CAM10: 3rd digit LE signal
CAM 9: 4th digit LE signal
CAM 29 to 32: Display data
CAM 28: 1st digit LE signal
CAM 27: 2nd digit LE signal
CAM 26: 3rd digit LE signal
CAM 25: 4th digit LE signal
3 3-digit automatically
switching present
angle/speed output
(with units)
CAM 13 to 16: Display data
CAM 12: 1st digit LE signal
CAM11: 2nd digit LE signal
CAM10: 3rd digit LE signal
CAM 9: “Degrees” units output
CAM 8: “r/min” units output
CAM 29 to 32: Display data
CAM 28: 1st digit LE signal
CAM 27: 2nd digit LE signal
CAM 26: 3rd digit LE signal
CAM 25: “Degrees” units output
CAM 24: “r/min” units output
4 4-digit automatically
switching present
angle/speed output
(with units)
CAM 13 to 16: Display data
CAM 12: 1st digit LE signal
CAM11: 2nd digit LE signal
CAM10: 3rd digit LE signal
CAM 9: 4th digit LE signal
CAM 8: “Degrees” units output
CAM 7: “r/min” units output
CAM 29 to 32: Display data
CAM 28: 1st digit LE signal
CAM 27: 2nd digit LE signal
CAM 26: 3rd digit LE signal
CAM 25: 4th digit LE signal
CAM 24: “Degrees” units output
CAM 23: “r/min” units output
Operation
Backlash compensation enable/disable Output hold
Present value
output setting
Use the mode selection switch to change to SET mode.
Various compensation value
enable/disable setting
• Display the present value output setting (Function No. H, Parameter No. 4) and the present settings
will flash in the SPEED/ON display.
• Use the Up and Down Keys to set the data.
Operation Chapter 3
To Next Page
Loading...
