2-24
H Cam Output Cable Connection Pin Positions and 3F88L-CGjjjS
Cam Output Cable Colors
Pin Layout
ExternalCam
Positioner
Cam output
COM/0V
Pin No. Signal name Cable color Pin No. Signal name Cable color
A1 NC Brown B1 NC Brown
A2 COM/0V Red B2 COM/0V Red
A3 CAM16 (CAM32) Orange B3 CAM8 (CAM24) Orange
A4 CAM15 (CAM31) Yellow B4 CAM7 (CAM23) Yellow
A5 CAM14 (CAM30) Green B5 CAM6 (CAM22) Green
A6 CAM13 (CAM29) Blue B6 CAM5 (CAM21) Blue
A7 CAM12 (CAM28) Purple B7 CAM4 (CAM20) Purple
A8 CAM11 (CAM27) Gray B8 CAM3 (CAM19) Gray
A9 CAM10 (CAM26) White B9 CAM2 (CAM18) White
A10 CAM9 (CAM25) Black B10 CAM1 (CAM17) Black
Note 1. Pin numbers have been given for convenience. The pin “A1”, indicated by the Y mark on the
protruding side, should be used as the starting pin number.
Note 2. The signal names in parentheses in the table will be applicable if the Cam Connector Cable is
connected to the connectors for cam outputs 17 to 32 (CAM17 to CAM32). These connectors
are not available on the 3F88L-160 16-point Cam Positioner.
Note 3. The maximum switching capacity for cam outputs is 26.4 V DC, 300 mA. However, keep this
at no more than 1.6 A per connector.
Note 4. The COM/0V connector is common to both A2 and B2 pins.
Note 5. If the present value output function is used, some cam outputs cannot be used.
Note 6. Reinforced insulation or double insulation must be used for the DC power supplies used as
I/O power supplies in order to comply EC Directives.
Design Chapter 2
To Next Page
Loading...
