Omron 3F88L-160 - Page 52

2-26
If set to an automatically switching display, the present angle will be displayed when the Resolver speed
is less than 4 r/min and the Resolver speed will be displayed when it is greater than 4 r/min.
D Unit Models Used
Name Model Remarks
Display Unit
(N l )
M7E-01DRD2 (red, decimal, one digit)
Combine as many Display Units
(N l ) i d hi h
py
(Numerals)
M7E-01DGD2 (green, decimal, one
digit)
ypy
(Numerals) as required to achieve the
required number of display digits.
Display Unit (Units)
M7E-01UR2-V (red, rpm)
If the automatically switching display
f i i b d Di l U i
py ( )
M7E-01UG2-V (green, rpm)
ygpy
function is to be used, two Display Units
(Units) are required an
“
r/min
”
Unit and
M7E-01UR2-A (red, no display)
(
Units
)
are required – an
“
r
/
min” Unit and
a
“
degrees
”
Unit.
M7E-01UG2-A (green, no display)
a degrees Unit
.
End Plate
M7E-2M (light-blue case)
One set is required.
M7E-2M-1 (black case)
q
Display Unit
Connector
NRT-C (soldered-terminal type) Enough connectors for the number of
Display Units is required.
Cam Output
Cbl
1 m 3F88L-CG001S
One Cam Output Cable is required.
p
Cable
3 m 3F88L-CG003S
pq
D Display Contents and Required Number of Units
Display Resolution
setting
Parameter
for present
Display
range
Required number of Units
se
tti
ng
f
or presen
t
value output
function
range
Numeric
Display Unit
Units
Display Unit
Display Unit
Connectors
Present
l
360 1 0 to 359 3 --- 3
angle
720 1 0 to 719 3 --- 3
r/min 360 2
0 to 999 3 --- 3
/
0 to 1,600 4 --- 4
720 2 0 to 800 3 --- 3
Switching
present
angle/r/min
display
360
3 0 to 359
(degrees)/
4 to 999
(r/min)
3 1 no display
Unit and 1
“rpm” Unit
5
py
4 0 to 359
(degrees)/
4 to 1,600
(r/min)
4 1 no display
Unit and 1
“rpm” Unit
6
720 3 0 to 719
(degrees)/
4 to 800
(r/min)
3 1 no display
Unit and 1
“rpm” Unit
5
Note 1. Refer to 3-5-2 Initial Settings for information on setting the display resolution.
Note 2. Refer to 3-6-10 Present Value Output Function for information on parameters for this function.
Note 3. One 3F88L-CGjjjS Cam Output Cable and one End Plate set are required when connect-
ing Units other than those listed in the above table.
Note 4. When the resolution is set at 720, the present angle display will read “1” for every 0.5°.
Design Chapter 2