1166
CS/CJ/NSJ Series Instructions Reference Manual (W474)
4. Instruction Execution Times and Number of Steps
4-1-29 Failure Diagnosis Instructions
4-1-30 Other Instructions
4-1-31 Block Programming Instructions
Instruction Mnemonic Length
(steps)
ON execution time (µs) Conditions
CJ2H
CPU6@(-EIP)
CJ2M CPU@@
FAILURE ALARM FAL 3 7.9 14.7 Recording errors
14.7 22.3 Deleting errors (in
order of priority)
12.9 22.5 Deleting errors (all
errors)
117 210 Deleting errors (indi-
vidually)
SEVERE FAILURE ALARM FALS 3 --- --- ---
FAILURE POINT DETEC-
TION
FPD 4 111 188 Bit address output,
time monitored
107 202 Bit address output,
first error detection
129 242 Message charac-
ters output, time
monitored
159 244 Message charac-
ters output, first
error detection
Instruction Mnemonic Length
(steps)
ON execution time (µs) Conditions
CJ2H
CPU6@(-EIP)
CJ2M CPU@@
SET CARRY STC 1 0.048 0.060 ---
CLEAR CARRY CLC 1 0.048 0.060 ---
SELECT EM BANK EMBC 2 7.6 14.6 ---
EXTEND MAXIMUM CYCLE
TIME
WDT 2 7.6 17.1 ---
SAVE CONDITION FLAGS CCS 1 5.8 8.3 ---
LOAD CONDITION FLAGS CCL 1 6.4 9.9 ---
CONVERT ADDRESS FROM
CV
FRMCV 3 9.4 15.7 ---
CONVERT ADDRESS TO CV TOCV 3 to 4 10.3 18.2 ---
DISABLE PERIPHERAL
SERVICING
IOSP 1 --- --- ---
ENABLE PERIPHERAL SER-
VICING
IORS 1 --- --- ---
Instruction Mnemonic Length
(steps)
ON execution time (µs) Conditions
CJ2H
CPU6@(-EIP)
CJ2M CPU@@
BLOCK PROGRAM BEGIN BPRG 2 7.8 14.1 ---
BLOCK PROGRAM END BEND 1 8.8 13.4 ---
BLOCK PROGRAM PAUSE BPPS 2 5.4 8.4 ---
BLOCK PROGRAM
RESTART
BPRS 2 3.6 4.8 ---
CONDITIONAL BLOCK EXIT (Execution con-
dition) EXIT
1 8.6 13.2 Block exited (input
condition ON)
2.0 2.6 Block not exited
(input condition
OFF)
To Next Page
Loading...
