185
Interrupt Functions Section 5-1
Creating an Interrupt
Task Program
1,2,3... 1. Select NewPLC1 [CP1H] Offline in the project workspace, right-click, and
select Insert Program in the pop-up menu. A new program called
NewProgram2 (unassigned) will be inserted in the project workspace.
2. Right-click NewProgram2 (unassigned) and select Properties from the
pop-up menu to display the Program Properties Window.
3. Set the Ta s k ty p e in the Program Properties Window.
In this example, interrupt task 140 was allocated to NewProgram2.
To Next Page
Loading...
