3-2 Setting the Routing Tables
3-2-5 Transferring Routing Tables
Note
If routing tables are transferred to the PLC from a Programming Device, the CPU Bus
Unit will be reset. The Unit is reset in order to read and enable the routing tables that
were transferred. Before executing the routing table transfer, verify that no equipment
will be damaged and it is safe for the CPU Bus Unit to be reset.
Note
The routing tables cannot be transferred to another network layer. When transferring
to a different network layer, directly connect the CX-Integrator to a PLC in that network
and transfer the routing tables.
3-22
To Next Page
Loading...
