4-3 Manually Setting Data Links
4-3-4 Creating Data Link Tables Offline
Note Fast Datalink Wizard Settings
It is possible to generate a table with all nodes set for the same PLC type and the
same areas (using Fast Default Table Generation), and then to modify individual
nodes in the Node Editing Window as required.
Make the settings as follows:
1 Click the Defaults Button and then set the default values in the following dialog
box.
2 Select the Fast Default Table Generation Option, and then click the Next Button
or press the Enter key.
The settings for all participating nodes will be generated at the above default
values.
• PLC type
• Memory area, data link start address, communications data size
• Status memory area
4-16
To Next Page
Loading...
