E5GN
5–13
Temperature input shift
The “input type” parameter must be set to
temperature input excluding a non-contact
temperature sensor.
Sometimes an error between the set point and the actual temperature occurs. To offset this, a
value obtained by adding an input shift value to the input is displayed as the measurement value
and used for control.
The entire input range is shifted by a fixed rate (1Ćpoint shift). If the input shift value
is set to Ć1_C", the set point is controlled to a value obtained by subtracting 1_C from
the actual temperature.
Setting Range Unit Default
-199.9 to 999.9 _C or _F 0.0
FĂRelated parameter
Input type" (initial setting level)
Upper-limit temperature
input shift value
Lower-limit temperature
input shift value
The “input type” parameter must be set to
only the non-contact temperature sensor.
Whereas the entire input range is shifted by a fixed rate (1Ćpoint shift) in the temperature input
shift" parameter, the input range is shifted by two points (2Ćpoint shift) at the upper and lower
limits. 2Ćpoint shift enables more accurate offset of the input range compared with 1Ćpoint shift,
if the input shift values at the upper and lower limits differ.
This parameter sets input shift values for each of the upper and lower limits (2Ćpoint
shift) of the input range.
Setting Range Unit Default
-199.9 to 999.9 _C or _F 0.0
FĂRelated parameter
Input type" (initial setting level)
Adjustment Level
Function
Setting
See
Function
Setting
See
To Next Page
Loading...
Need help?
General
