Omron E5GN - Page 93

CHAPTER 5 PARAMETERS
E5GN
5–26
Parameter initialize
This parameter returns parameter settings to their defaults.
: Initializes all parameters.
: Turns the E5GN OFF after returning parameter settings to their defaults.
Multi-SP uses
When the multiĆSP" parameter is set to ON", you can select set points 0 to 3 by operĆ
ating the keys on the front panel of the controller.
: You can select set points 0 to 3.
: You cannot select set points 0 to 3.
Ă• Default : OFF.
FĂRelated parameter
MultiĆSP" (operation level)
Advanced Function Setting Level
Function
Setting
Function
Setting
See