Omron FHV7 series User Manual

Additional Information
• You can change the Communicate Module after restarting. Restart it after loading, if you load
the system data that is changed the Communicate Module. For applying the details of
parameters after restarting, you should re-load the system data.
Additionally, you can load only once because the bkd data write the backup data at once.
• Layout settings will be applied when Switch layout is executed. Note that Layout change re-
mains until Switch layout is executed when System data which changes the layout setting is
loaded.
Precautions for Correct Use
• When the Scene data created via FZ series Sensor Controller, i.e. FZ5 series or FZ5-L ser-
ies, Camera Image Input is automatically converted to Camera Image Input FH.
The automatically converted contents is the common items between Camera Image Input
and Camera Image Input FH. The other settings is set to the default settings of the connect-
ed camera to the FH series Sensor Controller.
• When FZ series Sensor Controller loads data created by FH series Sensor Controller, the da-
ta will not be automatically converted.
9 Saving/Loading Data
9 - 14
FH/FHV Series Vision System User’s Manual (Z365-E1)

Omron FHV7 series Specifications

General

Brand	Omron
Model	FHV7 series
Category	Machine Vision Systems
Language	English