Omron FHV7 series User Manual

Although an error message such as the following, is not displayed, the ERROR signal and the ERR
indicator will turn ON.
Cause Troubleshooting
The STEP signal was input when the
READY signal was turned OFF.
• Input the STEP signal after the READY signal turns ON.
• Noise is superimposed onto the STEP signal. Keep PLC and
FH series/FHV series Sensor Controller away from the noise
source.
Notes:
• EtherCAT and EtherNet/IP error signals are not turned on.
A non-existing parallel command was en-
tered.
• Please enter a correct parallel command.
11 What to Do!
11 - 8
FH/FHV Series Vision System User’s Manual (Z365-E1)

Omron FHV7 series Specifications

General

Brand	Omron
Model	FHV7 series
Category	Machine Vision Systems
Language	English