Inspecting with the Labeling Inspection Item
152
FQ2 User’s Manual
Reflect in Total Judgement
You can specify whether to reflect the judgement results of an inspection item in the overall judgement. (The
default is to reflect them.)
[Inspect] − [Inspection] − [Add item.] − [Labeling] − [Details] Tab Page − [Output parameter]
Editing the Measurement Region
This section describes how to edit the measurement regions. You can edit the measurement region in the same
way as for a search region.
Changing the Model Registration Region to a Shape Other Than a Rectangle: p. 100
If the measurement region is changed, perform teaching if required.
p. 147
Measurement region
To Next Page
Loading...
Need help?
General
