Connecting a Previous Touch Finder (FQ-D30/D31) to the FQ2-S Sensor
496
FQ2 User’s Manual
11 Click the [Update Sensor List] Button.
12 Select the Sensor from the list and click the [Install] Button.
If Installation completed normally is displayed in the dialog box, the data has been overwritten normally.
13 Reset the Sensor.
• Restoring Inspection Items to the Sensor
It is not necessary to delete any inspection items to connect the FQ2-D30/D31 Touch Finder. To connect the
FQ2-D30/D31 Touch Finder after performing the above operation, repeat the above operation, but select all of
the inspection items in step 5 to re-register all of the inspection items in the original state.
To Next Page
Loading...
Need help?
General
