2 Instruction Descriptions
2-186
NJ-series Instructions Reference Manual (W502)
• If the value of In is 0.0, positive infinity, negative infinity, or nonnumeric data, the value of Out is as
shown below.
• If you pass an integer parameter to In, the data type is converted as follows:
Precautions for Correct Use
Value of In Value of Out
0
1.0
+∞ +∞
−∞
0.0
Nonnumeric data Nonnumeric data
Data type of parameter that is
passed to In
Data type of In
USINT, UINT, SINT, or INT REAL
UDINT or DINT LREAL
ULINT or LINT A building error will occur.
To Next Page
Loading...
