Omron NJ501-1500

2 Instruction Descriptions
2-462
NJ-series Instructions Reference Manual (W502)
The following example is for when OutVal and Size are the same as above and Order is _HIGH_LOW.
• If OutVal is a structure, some of the values of In[] may be inserted in adjustment areas between mem-
bers depending on the composition.
• If the value of Size is 0, the value of Out will be TRUE and OutVal will not change.
• Return value Out is not used when the instruction is used in ST.
• An error occurs in the following cases. ENO will be FALSE, and OutVal will not change.
• The value of Order is outside of the valid range.
• The value of Size exceeds the number of elements in In[].
Precautions for Correct Use
OutVal[0]
Size = UINT#3
TRUE
OutVal[2]
FALSE
FALSE
OutVal[1]
OutVal[3]
TRUE
OutVal[5]
FALSE
FALSE
OutVal[4]
OutVal[6]
FALSE
OutVal[7]
TRUE
OutVal[9]
TRUE
FALSE
OutVal[8]
OutVal[10]
OutVal[12]
FALSE
TRUE
FALSE
OutVal[11]
OutVal[13]
FALSE
OutVal[14]
TRUE
OutVal[16]
FALSE
OutVal[15]
OutVal[17]
OutVal[18]
OutVal[20]
OutVal[19]
In[0]
In[1]
In[2]
Not
changed.
Not
changed.
Not
changed.
Not
changed.
Not
changed.
BYTE#16#89
BYTE#16#45
BYTE#16#04