2 Instruction Descriptions
2-486
NJ-series Instructions Reference Manual (W502)
• If In[] is a three-dimensional array, the element number in the first dimension of the element that
matches the search conditions is assigned to InOutPos[0], the element number in the second dimen-
sion is assigned to InOutPos[1], and the element number in the third dimension is assigned to InOut-
Pos[2].
• When an element in the array is passed to In[], all elements below the passed element are pro-
cessed.
• If Member is a real number, depending on the value of Member, the desired results may not be
achieved due to error.
• If Key is a real number, do not specify nonnumeric data for Key.
• If the value of Size is 0, the value of Out is FALSE and the value of Num is 0. InOutPos[] does not
change.
• The correct result is not obtained if the value of Mode is _BIN_ASC or _BIN_DESC and the elements
of In[] are not in ascending or descending order. Place the elements in ascending or descending
order before executing this instruction.
• An error occurs in the following cases. ENO will be FALSE, and Out, InOutPos[], and Num will not
change.
• The value of Mode is outside of the valid range.
• The value of Size exceeds the array area of In[].
• Member is not a member of In[].
• The array size of InOutPos[] is smaller than the number of dimensions of In[].
• Member is not integer or real number data.
• Key and Member have different data types.
• In[] is not an array of structures.
Precautions for Correct Use
To Next Page
Loading...
