Omron NX1P2 series

NX Unit..................................................................... 2-5, 3-32
NX Unit Power Supply Capacity......................................
4-11
O
Operating environment......................................................A-2
Operating Mode at Startup................................................
5-4
Operating Procedure....................................................... 1-14
Operation until Operation Ready Status............................5-3
Option Board..................................................................... 2-5
Option board slot............................................................... 3-6
order of powering off..........................................................5-9
order of powering on..........................................................5-9
Output indicator................................................................. 3-6
Output Short-circuit Protection........................................ 5-67
Output Specifications.......................................................3-17
Output terminal block............................................... 3-6, 3-15
Overcurrent......................................................................4-25
P
Periodic Inspection Items.................................................. 7-3
POWER............................................................................. 3-
7
Power OFF Operation....................................................... 5-5
power supply-related Unit..................................................4-3
Power Supply-related Unit...............................................3-31
preventing incorrect attachment of terminal blocks......... 5-64
Protective device............................................................. 4-25
R
Recommended Power Supplies............................. 4-22, 4-24
Recommended screwdriver .........................
5-55, 5-74, 5-79
Release hole....................................................................3-12
removing a terminal block................................................5-62
replacement battery...........................................................7-6
Required Power Supply Capacity of the I/O Power Supply....
..................................................................................... 4-24
Required Power Supply Capacity of the Unit Power Supply..
..................................................................................... 4-22
restricted region...............................................................5-18
Restrictions on Inrush Current.........................................4-21
RS-232C Option Board....................................................3-23
RS-422A/485 Option Board.............................................3-24
RUN...................................................................................3-8
S
Safe Mode......................................................................... 3-6
Screw for securing...........................................................
3-12
SD BUSY...........................................................................3-8
SD Memory Card......................................................2-5, 5-28
SD Memory Card connector.............................................. 3-5
SD Memory Card cover..................................................... 3-6
SD Memory Card power supply switch..............................3-5
SD PWR............................................................................ 3-8
Securing Wires................................................................ 5-57
Selecting Protective Device.............................................4-25
solid wires........................................................................5-56
special marker printer...................................................... 5-27
Star earthing...........................................................5-90, 5-91
Startup...............................................................................
3-8
Supply from external source
............................................4-13
supply from the NX bus................................................... 4-13
Support Software........................................................1-6, 1-8
Sysmac Studio.................................................................3-33
T
Terminal hole................................................................... 3-12
The voltage drop in the I/O power supply
...............
4-14, 4-18
twisted wires.................................................................... 5-56
U
Unit hookup guide..............................................................3-6
Unit power supply.....................................................
4-2, 4-22
Unit Version..............................................................3-20, A-6
W
Wiring Ducts.................................................................... 5-14
Wiring the Unit Power Supply..........................................
5-44
Write Protection Key........................................................3-21
Index
I-3
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)
I