Omron NX701-1

6-41
6 Motion Control Programming
NJ/NX-series CPU Unit Motion Control User’s Manual (W507)
6-8 Programming Motion Controls
6
3 Editing the Program
Right-click a section in the new program and select Edit from the menu. The Program Edit Tab
Page is displayed.
Select the required instructions from the Toolbox and enter the program.
Refer to the NJ/NX-series CPU Unit Software User’s Manual (Cat. No. W501) for details on program-
ming.
Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) for specific procedures.