Omron Varispeed E7 User Manual

5-6
User Parameter Tables
 Setup Settings: A
 Initialize Mode: A1
Param-
eter
Number
Name Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Access
Level
MEMO-
BUS
Register
Page
A1-00
Language selec-
tion for Digital
Operator display
Used to select the language dis-
played on the LCD or HOA Digital
Operator only.
0:English
2:German
3:French
4:Italian
5:Spanish
6:Portuguese
This parameter is not changed by
the initialize operation.
0 to 6 0 Yes A 100H –
A1-01
Parameter access
level
Used to set the parameter access
level (set/read.)
0:Monitoring only (Monitoring
drive mode and setting A1-01
and A1-04.)
1:Used to select user parameter
(Only parameters set in A2-01
to A2-32 can be read and set.)
2:Advanced
(Parameters can be read and set
in both, quick programming
mode (Q) and advanced pro-
gramming (A) mode.)
0 to 2 2 Yes A 101H 6-117
A1-03 Initialize
Used to initialize the parameters
using the specified method.
0:No initializing
1110:Initializes using the user
parameters that have been
stored before using o2-03 para-
meter
2220:Initializes using a two-wire
sequence. (Initializes to the fac-
tory setting.)
3330:Initializes using a three-wire
sequence.
0 to
3330
0 No A 103H –
A1-04 Password
Password input when a password
has been set in A1-05.
This function write-protects
parameters of the initialize mode.
If the password is changed, A1-01
to A1-03 and A2-01 to A2-32
parameters can only be changed
after inputting the right password.
0 to
9999
0 No A 104H 6-117
A1-05 Password setting
Used to set a four digit number as
the password.
Usually this parameter is not dis-
played. When the password (A1-
04) is displayed, hold down the
RESET key and press the Menu
key and A1-05 will be displayed.
0 to
9999
0 No A 105H 6-117

Omron Varispeed E7 Specifications

General

Brand	Omron
Model	Varispeed E7
Category	Inverter
Language	English