109
ZX-E
Operation Manual
Section 5 Linear Output
Section 5
DETAILED SETTINGS
Setting the Second Point (B)
11. Use the same procedure as the first point to
set the correction value for the second point.
12. Press the ENT Key.
Confirming Setting Results
If linear output correction has been registered correctly,
the sub-display will show OK.
If the correction is not registered correctly, the display will
show NG.
Check that the current (or voltage) value for the two
points are not the same and execute again.
Z166-E1-02A.book Page 109 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
