84
Section 5 Using Hold Functions
ZX-E
Operation Manual
Section 5
DETAILED SETTINGS
Selecting Trigger Types
1. Use the LEFT and RIGHT Keys to display H-
TRG on the main display.
H-TRG will not be displayed if the hold condition is set to
OFF.
2. Press the UP or DOWN Key.
The sub-display will flash.
3. Use the UP or DOWN Key to select the trig-
ger type.
4. Press the ENT Key to confirm the selection.
The selected trigger type will be registered.
Setting Trigger Levels (when UP or DOWN Is Selected)
5. Use the RIGHT or LEFT Key to display H-
LVL on the main display.
H-LVL will not be displayed if timing input (TIMIG) is
selected as the trigger.
6. Press the UP or DOWN Key.
The leftmost digit of the sub-display will flash.
7. Use the Cursor Keys to set the trigger level.
8. Press the ENT Key to confirm the settings.
The trigger level will be registered.
Move between digits.
Increment and decre-
ment the numeric value.
Z166-E1-02A.book Page 84 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
