85
ZX-E
Operation Manual
Section 5 Using Hold Functions
Section 5
DETAILED SETTINGS
Setting Hysteresis Width (when UP or DOWN Is Selected)
9. Use the LEFT and RIGHT Keys to display H-
HYS on the main display.
H-HYS will not be displayed if timing input (TIMIG) is set
as the trigger.
10. Press the UP or DOWN Key.
The leftmost digit of the sub-display will flash.
11. Use the Cursor Keys to set the hysteresis
width for the trigger level.
12. Press the ENT Key to confirm the setting.
The hysteresis width will be registered.
Move between digits.
Increment and decre-
ment the numeric value.
Z166-E1-02A.book Page 85 Friday, June 3, 2005 4:18 PM
To Next Page
Loading...
