Maintenance
Version 1.0.4 - 2020-08-0460 Translation of original instruction
MT60
EN
MT60_GB_5.fm
When
necessary
Guideways
Readjusting
Readjust the guides by means of the corresponding V-
ledge.
If necessary disassemble the wipers in order to attain
the readjusting screws of the corresponding V-ledges.
Use a screwdriver to turn the adjusting screw clockwise
until the movement in the respective guideway is still
easily possible.
Img.6-4: V-ledge
Dismantle the wiper plate and wiper in order to reach
the adjustment screw.
Img.6-5: Y axis V-ledge
As required but
at least once
per year
Coolant equipment
Replacing
Fill in coolant, replace if necessary.
Wash the cooling lubricant pump.
Cooling lubricants and tanks on page 62
Inspection plan for water-mixed cooling lubricants on
page 63
Interval Where? What? How?
Milling table, milling head car-
rier, milling table, X, Y, Z
V-ledge
Adjustment screw
Adjustment
screw
Wiper
Wiper plate
To Next Page
Loading...
