Expansion Module Installation
3-14 StorageTek SL150 Modular Tape Library Installation Manual
Unpack and Acclimate the Expansion Module
■ Perform the unpacking instructions (see "Unpack and Acclimate the SL150
Library").
Expansion Module Attachment Kit
The expansion module (Module 2 through Module 10) accessory kit contains the
following attachment hardware (see Figure 3–14):
■ Back rails
■ 10–32 clip nuts (used in racks with square holes)
■ Assorted screws:
– 10–32 X 5/8 screws (used with clip nuts and racks with 10-32 threaded holes)
– M5 0.8 X 16 mm screws (used with M5 threaded hole racks)
– M6 16 mm screws (used with M6 threaded hole racks)
■ Expansion interconnect cable with USB Type A connectors
■ Label set (Module 2 through Module 10)
■ Hook and loop strap
■ Pop-in rivet
■ Hex key
Figure 3–14 Expansion Module Accessory Package Hardware
Illustration Legend:
1 - Back Rails
2 - Clip Nuts
3 - Screws (Assorted)
4 - Expansion Cable with USB Type A Connectors
5 - Module Labels
6 - Hook and Loop Strap
7-Rivet
8 - Hex Key
To Next Page
Loading...
Need help?
General