C-2 StorageTek SL150 Modular Tape Library Installation Manual
2.
Make sure the robot has positioned the hand against the ceiling and front face of
the library (see Figure C–2).
Figure C–2 Hand Position After Power Down
Task 3 Install the Shipping Clip
1. Grasp the shipping clip and reach through the cartridge magazine opening.
2. Open the shipping clip and install it over the 7 mm steel shaft behind the hand
assembly (see Figure C–3).
3. Squeeze the clip to reduce the clamping force on the shaft and slide the clip
toward the hand assembly (see Figure C–4).
The hand will be contained between the front wall and the clip.
4. Guide the instruction tag out of the cartridge magazine slot.
Figure C–3 Shipping Clip Installation
Illustration Legend:
To Next Page
Loading...
