Oracle storagetek sl150 - Configure Local Area Network Port 1; Use Both Internet Protocol Version 6 (IPv6) and Version 4 (IPv4)

Expansion Module Installation
3-24 StorageTek SL150 Modular Tape Library Installation Manual
4.
Orient the label properly, align the label with the scribe lines, and adhere the label
to the chassis (see Figure 3–25).
5. Continue with the next section ("Install the Hook and Loop Strap").
Figure 3–25 Expansion Module ID Label
Illustration Legend:
1 - Module Label
2 - Horizontal Scribe Line
3 - Vertical Scribe Line
Install the Hook and Loop Strap
Follow these instructions to install the hook and loop strap:
1. Insert the rivet into a hole in the hook and loop strap (see Figure 3–26).
Figure 3–26 Hook and Loop Strap
Illustration Legend:
1 - Module Controller
2 - Hook and Loop Strap
3-Rivet
2. Pull the plunger back from the rivet face.
3. Align the rivet with the hole beside the module controller.
4. Push the rivet into the hole.