Step 3 of 6 (Set the Librar y Date and Time)
4-8 StorageTek SL150 Modular Tape Library Installation Manual
The Set the Drive Element Addressing Mode screen appears.
Figure 4–8 Library Time Zone and Closest City or Region
Configure the Date and Time
Use the Configure Date and Time list to select either Manually or Using Network
Time Protocol.
■ If you select Using Network Time Protocol, you must provide the IP address of a
Network Time Protocol server on your network. The steps are similar to those for
setting an IP address for Network Port 1.
■ If you select Manually, you must provide additional information.
Set the Date Manually
To set the date manually:
1. Tap the keyboard button.
The Letters screen appears with the parameter field showing Date.
2. Tap the Clear button to remove any existing date value.
3. Tap the screen keys to enter the current date in the format MM/DD/YYYY.
4. Tap the Next button after entering the last digit for the year.
Figure 4–9 Library Date and Time
To Next Page
Loading...
Need help?
General