Run the Self-Test
5-4 StorageTek SL150 Modular Tape Library Installation Manual
Illustration Legend:
1 - Self Test Activity
2 - Diagnostic Cartridge in the Top Drive of Module 1
2. Verify successful test completion.
Figure 5–4 Self Test Complete
Illustration Legend:
1 - Self Test Completed
2 - Diagnostic Cartridge Returned to the Reserved Slot
Task 3 Finish Up
1. Set the library to the Library is Online state.
2. Remove the diagnostic tape from the mailslot, if applicable.
a. Select Open from the Mailslot list.
b. Extend the Mailslot mechanism from the base module to access the diagnostic
tape.
c. Grasp the diagnostic tape and pull it out of the slot.
d. Close the mailslot expansion first (if configured).
e. Push the Mailslot using a single, smooth motion into the library until it latches
into place with a noticeable click.
3. Log out if you will not be performing other operations.
Note: The library map has visual indications of cartridge
movement from a slot to the robot and to a destination (tape drive,
mailslot, or a cartridge slot).
Note: Refer to the information in the section titled "Incomplete
Test" if the test does not complete successfully or you stop the test.
To Next Page
Loading...
Need help?
General