Step 6 of 6 (Review and Apply Initialization Settings)
4-12 StorageTek SL150 Modular Tape Library Installation Manual
Step 6 of 6 (Review and Apply Initialization Settings)
The last step of library initialization is to review and apply the initialization settings
(see Figure 4–12).
Figure 4–12 Review and Apply Changes
Illustration Legend:
1 - Scroll Bar
2 - Apply Button
Apply Changes
To apply changes:
1. Verify the value of each initialization setting.
2. Tap the Apply button.
The library performs a restart (see Appendix A, "Startup"). The duration of the
restart varies based upon the number of modules in the library.
After the restart completes, the Home screen appears on the touch screen (see
Figure 4–13).
Note: If an incorrect value is applied, you must return the library
to factory default values and repeat the entire initialization process
(see "Reset the Library with Manufacturing Default Values").
Note: Alter any incorrect value before applying changes by
tapping the Previous button.
Caution: Do not manually remove a cartridge magazine while the
library is performing the restart. Only perform a manual cartridge
magazine removal when the library is operational and offline.
To Next Page
Loading...
