range Pi 用户手册 深圳市迅龙软件有限公司版权所有
www.orangepi.cn 44 www.xunlong.tv
[ OK ] Started Update UTMP about System Runlevel Changes.
[ OK ] Started Authorization Manager.
Orange Pi 2.1.0 Bionic ttyS0
orangepi login:
3.10.
Ethernet port test
1) First, insert the network cable into the Ethernet interface of the development board,
and ensure that the network is unblocked
2) After the system starts, it will automatically assign an IP address to the Ethernet card
through DHCP
3) The command to view the IP address is as follows
root@orangepi:~# ifconfig eth0
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.1.47 netmask 255.255.255.0 broadcast 192.168.1.255
inet6 fe80::e56:c34d:62f0:8d6e prefixlen 64 scopeid 0x20<link>
ether 02:81:3e:a8:58:d8 txqueuelen 1000 (Ethernet)
RX packets 2165 bytes 177198 (177.1 KB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 312 bytes 40435 (40.4 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 39
4) The command to test network connectivity is as follows
root@orangepi:~# ping www.orangepi.org -I eth0
PING www.orangepi.org (182.92.236.130) from 192.168.1.47 eth0: 56(84) bytes of data.
64 bytes from 182.92.236.130 (182.92.236.130): icmp_seq=1 ttl=52 time=39.3 ms
64 bytes from 182.92.236.130 (182.92.236.130): icmp_seq=2 ttl=52 time=39.3 ms
64 bytes from 182.92.236.130 (182.92.236.130): icmp_seq=3 ttl=52 time=39.9 ms
64 bytes from 182.92.236.130 (182.92.236.130): icmp_seq=4 ttl=52 time=39.7 ms
64 bytes from 182.92.236.130 (182.92.236.130): icmp_seq=5 ttl=52 time=39.7 ms
To Next Page
Loading...
