range Pi 用户手册 深圳市迅龙软件有限公司版权所有
www.orangepi.cn 70 www.xunlong.tv
root@orangepi:~#
12) Before using motion, please make sure that the Orange Pi development board can be
connected to the network normally, and then obtain the IP address of the development
board through the ifconfig command
13) Then enter [development board IP address: 8081] in the Firefox browser to see the
image output by gc2035
3.21.3. Linux3.4 system ov5640 camera test
1) First connect the Ov5640 camera adapter board to the CIS camera interface of the
development board through a cable, and then start the linux system after connecting the
camera (don’t plug in the camera after powering on)
2) Then use the setsystem ov5640 command to initialize the configuration of ov5640
root@orangepi:~# setsystem ov5640
To Next Page
Loading...
