range Pi 用户手册 深圳市迅龙软件有限公司版权所有
www.orangepi.cn 72 www.xunlong.tv
to start_motion_daemon=yes
root@orangepi:~# sed -i "s/start_motion_daemon=no/start_motion_daemon=yes/" \
/etc/default/motion
7) Modify the configuration of /etc/motion/motion.conf
root@orangepi:~# sed -i "s/stream_localhost on/stream_localhost off/" \
/etc/motion/motion.conf
8) Then restart the motion service
root@orangepi:~# /etc/init.d/motion restart
[ ok ] Restarting motion (via systemctl): motion.service.
root@orangepi:~#
9) Before using motion, please make sure that the Orange Pi development board can
connect to the network normally, and then obtain the IP address of the development board
through the ifconfig command
10) Then enter [development board IP address: 8081] in the Firefox browser to see the
image output by ov5640
3.21.4.
Linux5.4 system ov5640 camera test
1) linux5.4 system currently only supports ov5640 camera, not gc2035
To Next Page
Loading...
