To Next PageTo Next PageWhy torque cannot be limited on Oriental motor BLH Engine?
If torque cannot be limited on the Oriental motor Engine, check the connection and the ON-OFF status of the signal. The signal input status can be checked using the internal I/O monitor or D-I/O monitor. If the TL input is turned OFF, the torque limiting function is disabled.
Why is Oriental motor BLH Engine rotating in the opposite direction?
If the Oriental motor Engine rotates in the opposite direction, check the following: * The ON-OFF operation of the FWD/REV input might be used incorrectly, or the FWD/REV input might not be connected correctly. Check the connection and the ON-OFF status of the signal, using the internal I/O monitor or D-I/O monitor. * The setting of the "Motor rotation direction" parameter may have been changed. The motor rotates forward when the FWD/REV input is ON. The forward rotation setting can be configured with the "Motor rotation direction" parameter (initial value: +=CW).
Why is the stopping time long for my Oriental motor Engine?
If the stopping time is long for the Oriental motor Engine, and the stopping method is wrong, consider these solutions: * Check the stopping method. In the 3-wire mode, stopping by turning the RUN/BRAKE input OFF differs from turning the START/STOP input OFF. In the 2-wire mode, stopping when the STOP-MODE input is ON differs from when it is OFF. * The load inertia may be too large. Increase the frictional load or reduce the load inertia.
General| Brand | Oriental motor |
|---|---|
| Model | BLH Series |
| Category | Engine |
| Language | English |
