warranty legislations.
1.2 CONTROL BEFORE DELIVERY
This machine is tested, controlled and has passed final inspection, before leaving the factory.
1.2.1 Preparation at customer location
Orkel AS will set-up the machine for the customer if requested/agreed. An introduction course, both in hand-
ling and operating the compactor will be held at site if requested/agreed. During commissioning and start-
up period, we’re offering our technical assistance and answering all questions regarding the compactor
start-up.
NOTE: Please see the delivery - warranty formula included with the user manual.
1.3 IDENTIFICATION OF THE MACHINE
A sticker describing the serial number is located on the right side of the machine. In addition, the number is
also imprinted on top of the frame. See Figure 1.1.
The serial number must always be provided when contacting your dealer, either it’s for ordering parts or
technical assistance.
The serial number is the safest way to identify your machine. Do not remove or change the serial number.
Figure 1.1 :
Serial number location
1.4 THE OPERATORS MANUAL
1.4.1 How to use this manual
This manual is organized after the «see—think—use»-principle. The content and explanations are arranged
in smaller sequential operations, and the main chapters are arranged according to the normal use of the
machine (Example: Setup —> Operation —> Maintenance).
Chapter overview:
1 GENERAL 11
To Next Page
Loading...