Make sure that the compactors main power switch is on before running the PTO, as to avoid over-
loading and/or damaging the compactor's electrical system.
14. Start the tractors PTO.
IMPORTANT: Check the rotational direction of the PTO (see chapter 4.2.6 "Power take off")
15. Run the PTO at about 300 RPM.
16. Maintain this speed until the oil has reached the appropriate operating temperature. See chapter
4.2.10 "Oil temperature".
17. Increase the PTO speed to 850 rpm.
18. Lower the wrapping table to its horizontal position using the display unit.
19. Fold down the bale bridge. Perform a function test of all the emergency stop switches before starting
baling.
Perform a function test of all the emergency stop switches before starting baling.
4.2.2 Lever/Controls overview
Figure 4.1 :
Lever/Controls overview MC850
See section 3.3.1 "Control panels" for descriptions of the levers/controls regarding the feed hopper.
4.2.3 Lever list
Lever no: Valve function
1 Left support leg, rear Up / down
4 OPERATION 33
To Next Page
Loading...
