When loading the system with a new roller of net/film, shut down the machine and thread the net/film as
shown on the illustration below. In order to ease the handling of the net/film, the brake should be released.
The brake automatically disengages when opening the rollers. If this for some reason doesn't happen, this
may be done from the display unit () or the remote control (section 3.6.4 "Remote control") on the platform.
Figure 3.3 :
Plastic tying unit
3.6.2 Brake and feed speed
The speed should be set so that the net/film is fed at a slightly higher speed than the bale’s peripheral
speed. Depending on whether net or film is used, and what material is being baled, the brake force must be
set accordingly. In general, it is desirable to keep the brake force as high as possible in order to maintain a
high density bale. The brake force should be set when net/film is pulled during the automatic net/film
sequence. The brake force is shown on the brake pressure gauge. The valve for the brake pressure is adjus-
ted consecutively until the appropriate brake force is reached. Start the adjustment with a low brake force,
and increase it. If the brake force is too high, this might damage or even rupture the net or film.
3 SETTINGS AND HYDRAULIC ADJUSTMENTS 24
To Next Page
Loading...
