NOTE
The CTI system should be in ON position only when parked during
cold starts in cold environments. CTI will adjust tire pressures during
warm up period while HET Tractor is parked.
a. Move CTI switch to OFF position before moving HET Tractor. (WP 0028)
b. Drive HET Tractor 3 to 5 miles (5 to 8 km).
c. Move CTI switch to ON position and select appropriate terrain position.
(WP 0028)
CAUTION
Avoid using LOW transfer case with transmission selector in 1 (first
range). If using LOW transfer case & 1 (first range), do not exceed 1200
RPM when starting from a stop. If the tractor does not move prior to
reaching 1200 RPM, do not continue to increase engine RPM. Failure to
comply may result in driveline damage.
4. Set transmission range selector (2) to 1 position and TRANSFER CASE shift lever
(3) to HIGH position. Drive HET Tractor at the lowest possible speed to warm driveline
components and tires.
OVERSPEED
LOW AIR
START
CTI OFF - ON
CTI CONTROLLER MODEL 101
CROSS COUNTRY
HIGHWAY
MUD SAND & SNOW
9 MAX SPEED 45 MPH)
(MAX SPEED 30 MPH)
( MAX SPEED 15 MPH)
( MAX SPEED 5 MPH)
EMERGENCY
CHECK
GAUGES
CHECK
ENGINE
AIR
LOW
TRAILER
AIR SUPPLY
PARKING
BRAKE
2
3
Figure 2.
TM 9-2320-360-10 0076
0076-3
To Next Page
Loading...
