a. Release accelerator pedal (7).
b. Steer in direction of slide until HET Tractor stops.
c. Press accelerator pedal (7) slowly. Steer HET Tractor on straight course.
11. If HET Tractor becomes stuck:
CAUTION
Avoid using LOW transfer case with transmission selector in 1 (first
range). If using LOW transfer case & 1 (first range), do not exceed
1200 RPM when starting from a stop. If the tractor does not move
prior to reaching 1200 RPM, do not continue to increase engine
RPM. Failure to comply may result in driveline damage.
a. Shovel clear path ahead of each wheel. Put boards, brush, mats, canvas, or
similar material in cleared paths to get better tire traction.
b. Set CTIS rotary selector switch (4) to MUD, SAND & SNOW position.
(WP 0028)
c. Set TRANSFER CASE shift lever (3) to LOW position.
d. Set DRIVELINE control (5) to LOCK position.
e. Set transmission range selector (2) to 1 position.
f. Accelerate slowly so tires do not spin.
g. If HET Tractor remains stuck, set CTIS rotary selector switch (4) to
EMERGENCY position.
h. Use another vehicle to recover.
NOTE
Model A dash panel shown, Model B dash panel similar.
12. To park HET Tractor:
a. Park HET Tractor so it does not face into wind when possible.
b. Park HET Tractor on dry ground when possible. Place wood planks, brush,
mats, or canvas under tires if dry ground is not available.
NOTE
Do not apply parking brake in extremely cold weather. Brake shoes
can freeze to brake drum. Ensure HET Tractor is parked on level
terrain and wheels are chocked.
c. Park HET Tractor on level ground.
d. Set TRANSFER CASE shift lever (3) to LOW position.
TM 9-2320-360-10 0076
0076-7
To Next Page
Loading...
