Table 1. PMCS - BEFORE - Continued
Item
No.
Interval
Item to
be
Checked
or
Serviced
Procedure
Equipment
Not Ready/
Available If:
since the last weekly
inspection.
•
You are operating the
vehicle for the first time.
NOTE
•
Clean all lubrication
points with solvent
cleaning compound and
allow to dry prior to
servicing.
•
When using a grease
gun, apply lubricant to the
fitting until clean lubricant
squeezes out of the part
being lubricated.
•
Always refer to
Lubrication Instructions
to ensure equipment has
correct lubricants
appropriate to operating
environment (expected
continuous
temperatures). If not,
remove/drain and
reapply/refill equipment
with appropriate
lubricants for operating
environment as
prescribed in Lubrication
Instructions.
NOTE
If leakage is detected, further
investigation is needed to de-
termine the location and
TM 9-2320-360-10 0100
0100-2
To Next Page
Loading...
