16
INTENDED USE
The L4Cc and L6Cc combiner are intended for delivering optical signals in industrial, and laboratory
environments. Use the product only for its designated purpose. Observe the operating conditions and
performance limits stated in the data sheet.
Using the combiner or any laser source without its remote control is equivalent to
using the source as an OEM part. The OEM version is intended for integration into a
larger system supervised by the user and should therefore not be used "as is" in
another environment such as a laboratory. The equipment into which the combiner
is integrated must comply with the laser safety standards listed in section
“Warranty and certification”.
Oxxius shall bear no responsibility for a lack of compliance with the applicable
safety standards or local regulations, in the event where a plug-and-play combiner
would be used without its dedicated remote control.
To Next Page
Loading...