45
Click on “Shutter activation” and select one of the control sources:
• from software commands, or
• from signal received from the I/O port. The boxes underneath allow the user to select the pin
number on the I/O port. The diagram of the I/O port will be updated accordingly.
EXTENSION MODULES
Click on the name of the module that you need to configure, then select one of the control sources:
• from software commands, or
• from signal received from the I/O port. The boxes underneath allow the user to select the pin
number on the I/O port. The diagram of the I/O port will be updated accordingly.
4-5 Using the control software
RUNNING THE CONTROL PROGRAM
DEVICE DETECTION
Launch the executable file from your “Program” menu or from the installation directory. On start-up, the
first window appearing on the left lists the devices detected on the USB ports.
To Next Page
Loading...