Chapter 3 Navigating and Entering Data
24
symbol after a down stroke is dependent upon where the down stroke was
drawn.
■ The screen is divided into two parts: one for writing lowercase letters and one
for writing numbers. Capital letters are formed across the imaginary line that
divides the two areas.
To write Graffiti 2 characters:
1. Tap the screen where you want your text to appear.
You must see a blinking cursor before you write the text.
2. Use the tables on the following pages to find the stroke shape for the letter you
want to create. For example, the stroke shown below creates the letter n.
3. Position the stylus in the left side of the screen.
4. Start your stroke at the heavy dot, and draw the stroke shape as it appears in the
tables.
5. Lift the stylus from the screen at the end of the stroke shape.
When you lift the stylus from the screen, your handheld recognizes your stroke
immediately and prints the letter at the insertion point on the screen.
As soon as you lift the stylus from the screen, you can begin the stroke for the next
character you want to write.
Write letters here Write numbers here
Start stroke
at heavy dot
Lift stylus
here
To Next Page
Loading...
Need help?
General
