EasyManua.ls Logo

Panasonic CPC-EX - Recording and Playing Messages

Panasonic CPC-EX
204 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 5. Peripheral Equipment
Section 300-Installation
5-26 DBS Manual - Revised April 2000 DBS-2.3/9.2-300
Recording and Playing Messages
You can record the VAU messages from either an extension or a trunk.
Notes:
You must use a DTMF telephone to record and play VAU
messages. To change existing messages, record over them.
To record and play messages, complete the following steps.
1. Do one of the following:
2. After the VAU answers, do one of the following:
Notes:
You can enter the *97 codes again to replay messages without
ending your call. You can only record one message at a time. To record
another message, you must end your call and redial the VAU.
3. When the operation is complete, put the phone on hook.
Note:
For more information on the VAU and its operation, see Section
770, “Voice Announce Unit User Guide.”
If . . . Then . . .
You are recording or play-
ing from an extension
Take your phone off hook.
Dial the VAU extension number. (If the intercom is set for
Voice, dial
1
to change from Voice to Tone.)
You are recording or play-
ing from a trunk
Dial the phone number of the VAU, or call in and have the opera-
tor transfer you to the VAU extension.
If . . . Then . . .
You want to record the
first message
Dial
* 98 1
Wait for a beep. After the beep, record the message.
You want to record the
second message
Dial
* 98 2
Wait for a beep. After the beep, record the message.
You want to play the first
message
Dial
* 97 1
The VAU plays the message.
You want to play the
second message
Dial
* 97 2
The VAU plays the message.

Table of Contents

Related product manuals