12-141
Table of MEWTOCOL-COM Communication Error
Error
code
Name Description
!21 NACK error Link system error
!22 WACK error Link system error
!23 Unit No. overlap Link system error
!24
Transmission format
error
Link system error
!25
Link unit hardware
error
Link system error
!26 Unit No. setting error Link system error
!27 No support error Link system error
!28 No response error Link system error
!29 Buffer closed error Link system error
!30 Time-out error Link system error
!32
Transmission
impossible error
Link system error
!33 Communication stop Link system error
!36 No destination error Link system error
!38
Other communication
error
Link system error
!40 BCC error A transfer error occurred in the received data.
!41 Format error A command was received that does not fit the format.
!42 No support error A command was received that is not supported.
!43
Multiple frames
procedure error
A different command was received when processing multiple
frames.
!50 Link setting error
A route number that does not exist was spacified. Verify the
route number by designating the transmission station.
!51
Transmission
time-out error
Transmission to anather device not possible because
transmissition buffer is congested.
!52
Transmit disable
error
Transmission processing to another device is not possible.(Link
unit runaway,etc.)
!53 Busy error
Command process cannot be received because of multiple
frame processing.Or,cannot be received because command
being processed is congested.
!60 Parameter error Content of spacified parameter does not exist or cannot be used.
!61 Data error
There was a mistake in the contact,data area,data number
desigination,size designation,range,or format designation.
!62
Registration over
error
Operation was does when number of registrations was exceeded
or when there was no registration.
!63 PC mode error
PC command that cannot be processed was executed during
RUN mode.
To Next Page
Loading...
Need help?
General
