Characters,
Factory Default
Setting Item, Setting Range
Step time unit
Hours:Minutes
Minutes:Seconds
Power restore action
Stops after power is restored
Continues (resumes) after power is restored.
Suspends (on hold) after power is restored.
Program start temperature
Setting range: Scaling low limit value to Scaling high limit value (*1)
Program control start type
PV start
PVR start
SV start
Number of repetitions
Setting range: 0 to 10000 times
SV Rise/Fall rate start type
SV start
PV start
SV rise rate
Setting range: 0 to10000 /min ( /min)
Thermocouple, RTD inputs with a decimal point: 0.0 to 1000.0 /min ( /min)
DC voltage, current inputs: 0 to 10000/min
SV fall rate
Setting range: 0 to10000 /min ( /min)
Thermocouple, RTD inputs with a decimal point: 0.0 to 1000.0 /min ( /min)
DC voltage, current inputs: 0 to 10000/min
Indication when control output OFF
OFF indication
No indication
PV indication
PV indication + Any Alarm active
AT bias
Setting range: 0 to 50 (0 to 100 ), or 0.0 to 50.0 (0.0 to 100.0 )
AT gain
Setting range: 0.1 to 10.0 times
Output status when input errors occur
Output OFF
Output ON
OUT/OFF key function
Control output OFF function
Auto/Manual control
Program control
Auto/Manual after power interruption
Automatic control
Manual control
(*1) The placement of the decimal point follows the selection.
To Next Page
Loading...
