8.10 Items to be Initialized by Changing Settings
If settings are changed, the following items will be initialized.
Yes: Initialized
No: Not initialized
Setting item to be
Item changed
to be Initialized
Input Type
Event output
EV1 allocation
Event output
EV2 allocation
Transmission
output
SV1 to SV9
Yes
No No No
Steps 1 to 9 wait value
Yes
No No No
AT bias
Yes
No No No
OUT1 proportional band
Yes
No No No
Manual reset
Yes
No No No
SV rise rate
Yes
No No No
SV fall rate
Yes
No No No
Scaling high limit
Yes
No No No
Scaling low limit
Yes
No No No
Program start temperature
Yes
No No No
EV1 alarm value
Yes Yes
No No
EV1 high limit alarm value
Yes Yes
No No
Loop bread alarm time
Yes
No No No
Loop bread alarm span
Yes
No No No
EV2 alarm value
Yes
No
Yes
No
EV2 high limit alarm value
Yes
No
Yes
No
OUT2 proportional band
Yes
No No No
EV1 alarm value 0 Enabled/Disabled
No
Yes
No No
EV1 alarm hysteresis
No
Yes
No No
EV1 alarm delay time
No
Yes
No No
EV1 alarm Energized/De-energized
No
Yes
No No
EV2 alarm value 0 Enabled/Disabled
No No
Yes
No
EV2 alarm hysteresis
No No
Yes
No
EV2 alarm delay time
No No
Yes
No
EV2 alarm Energized/De-energized
No No
Yes
No
Sensor correction coefficient
Yes
No No No
Sensor correction value
Yes
No No No
To Next Page
Loading...
