Panasonic KV-S1057C - Conveyor Roller; Side Plate Assembly

34
7.4.5. Side Plate Assembly
7.4.6. Conveyor roller
(1) Remove the Back Cover. (See Back Cover (P.26))
(2) Remove the screws A and remove the Earth Plate with the
wire.
(3) Remove the 2 screws C and the Side Plate Assembly.
Reassembling Note:
Make sure to position the Idle Pulley of the Side Plate
Assembly outside of the Conveyor Belt 2.
(1) Remove the Side Plate Assembly and Conveyor Belt 2. (See
Side Plate Assembly (P. 34 ))
(2) Pull and remove the Pulley of the Conveyor Roller (arrow 2),
while unlocking the hook (arrow 1) on the Pulley.
Note:
After reassembling the Pulley, be sure to check that the
Pulley is locked to the Conveyor Roller by pulling the
Pulley.
(3) Slide and remove the bearing from the Conveyor Roller
(arrow 3).
(4) Open and remove the Feed Roller Cover.
(5) Unlock the hook of the Conveyor Roller Bearing (arrow 4)
(6) Unlock the Conveyor Roller by turning the Conveyor Roller
Bearing (arrow 5),
(7) Slide the Conveyor Roller with the Conveyor Roller Bearing
(arrow 6) and remove it (arrow 7).
(8) Remove the Support Bearing.
(9) Remove the polyslider.
(10) Remove the Conveyor Roller Bearing from the Conveyor
Roller.
Idle Pulley
Idle Pulley
Conveyor Belt 2
tension
C
A
Earth Plate
Side Plate Assembly
C
Bearing
Pulley
Conveyor
Roller
Hook
1
2
3
Feed Roller
Cover
Conveyor Roller
Conveyor
Roller
Bearing
Support
Bearing
(9)
4
5
6
7
Conveyor Roller Bearing
Support Bearing
Polyslider