Panasonic KV-S1057C - Care and Maintenance; Cleaning the Outside of the Scanner

50
9.3.7. Adjustment
Item Operation Default Remarks
Shading 1. Click “Adjust” on the main menu.
2. Click “Shading” on the Adjust menu.
3. Set the resolution (300 dpi and/or 600 dpi).
4. Clean the conveyor, rollers, and scanning glass section
according to the message on the display.
Then click “OK”.
5. Set the Shading Sheet (Part No.: See.
Tool (P.144)) on the
Feed Tray in portrait orientation.
6. Click “OK” to start the shading correction.
7. Confirm the result.
8. Click “OK” to return to the Adjust menu.
— Until this process is
completed, don’t stop the
process by opening any
doors or turning off the
scanner.
All Position 1. Click “Adjust” on the main menu.
2. Set 2 pcs of Test Chart A4 (Part No.: See.
Tool (P.144)) on the
Feed Tray in portrait orientation.
3. Click “All position” on the Adjust menu to execute scanning
position and length adjustment.
4. Check the result.
5. Click “OK” to return to the Adjust menu.
— Set 2 pcs of Test Chart A4 on
the Feed Tray in the
following order:
1st page: Front side
(Face-down)
2nd page: Back side
(Face-up)
Individual Position 1. Click “Adjust” on the main menu.
2. Adjust Automatically.
a. Set Test Chart A4 (Part No.: See.
Tool (P.144)) on the Feed
Tray in portrait orientation.
b. Click “Individual Position” on the Adjust menu.
c. Click one of 5 “Adjust Automatically” buttons to execute
the adjustment.
d. Check the result.
e. Click “OK” to finish the adjustment.
f. Click “OK” to return to the Adjust menu.
3. Adjust Manually.
a. Click “Individual Position” on the Adjust menu.
b. Change the parameters (mm, %) as required.
(Refer to Remarks.)
c. Click “OK” to renew the setting, and to return to the
Adjust menu.
— 1. Adjust Automatically
(5 adjustments)
Set face-down
Length
Front V. Position
Front H. Position
Set face-up
Back V. Position
Back H. Position
2. Adjust Manually
(Length)
+: Increasing the number
makes the scanning
document length shorter.
(Vertical Position)
+: Increasing the number
makes the document
scanning position shifted
upward.
(Horizontal Position)
+: Increasing the number
makes the document
scanning position shifted
to the left.
Note:
If the appropriate
scanning position can
not be obtained by any
of the manual
adjustments, check the
CIS installation.