Panasonic KV-S1057C - Bottom Plate; CONTROL Board; Fan; Lower Chassis

36
7.5. Lower Chassis 2
7.5.1. Bottom Plate
7.5.2. Platen Motor
7.5.3. FAN
7.5.4. Power Supply
7.5.5. CONTROL Board
(1) Remove the Back Cover. (See Back Cover (P.26))
(2) Remove the screw A and the USB Earth Plate.
(3) Remove the 7 screws C.
(4) Remove the 2 screws F.
(5) Remove the Bottom Plate.
Reassembling Note:
Install the Bottom Plate with screws C and F first and then
install the USB Earth Plate with screw A.
Otherwise the USB Earth Plate may not contact with the
USB jack on the Control Board correctly.
(1) Remove the Bottom Plate. (See
Bottom Plate (P. 3 6))
(2) Remove the screw C.
(3) Remove the Platen Motor with Motor Plate.
(4) Remove the 2 screws G and remove the Platen Motor from
the plate.
(1) Remove the Bottom Plate. (See
Bottom Plate (P. 3 6))
(2) Remove 2 screws E.
(3) Disconnect the connector on the CONTROL Board.
(4) Remove the FAN.
(1) Remove the Bottom Plate. (See
Bottom Plate (P. 3 6))
(2) Remove the 2 screws C.
(3) Remove the Power Supply.
(4) Disconnect the connector from the CONTROL board on the
Power Supply.
(1) Remove the Bottom Plate. (See
Bottom Plate (P. 3 6))
(2) Disconnect all connectors (7 cable connectors and 4 FFC
cables) to CONTROL Board.
(3) Remove the CONTROL Board
F
AUSB Earth Plate
Bottom Plate
C
Control Board
C
G
Platen Motor
Motor Plate
Power Supply
FAN
C
E
Control Board