Panasonic KV-S1057C - Exit Roller

35
7.4.7. Exit Roller
(1) Remove the Side plate Assembly (See Side Plate Assembly
(P. 34 )) and the Conveyor Belt 2
(2) Pull and remove the Pulley of the Exit Roller (arrow 2), while
unlocking the hook (arrow 1) on the Pulley.
Reassembling Note:
After reassembling the Pulley, be sure to check that the
Pulley is locked to the Exit Roller by pulling the Pulley.
(3) Slide and remove the Bearing from the Exit Roller (arrow 3).
(4) Unlock the hook of the Conveyor Roller Bearing (arrow 4).
(5) Unlock the Exit Roller by turning the Conveyor Roller Bear-
ing (arrow 5).
(7) Slide the Exit Roller with the Conveyor Roller Bearing and
remove it (arrow 6).
(8) Remove the Support Bearing.
(9) Remove the polyslider.
(10) Remove the Conveyor Roller Bearing from the Exit Roller.
Bearing
Exit Roller
Pulley
1
2
3
Hook
4
5
Exit Roller
Conveyor Roller Bearing
Support Bearing
Exit Roller
6
Conveyor Roller Bearing
Polyslider
Support Bearing